LOOKING TO BUY 360 HEADS!!!!

AlexMacTools · 05-10-2009, 07:06 PM

Looking to buy a good pair of heads for my 360, im looking for "Magnum" heads or standard 360 heads

Let me know im in the Southern California area, i will pick up if necessary.(will trade tools, and will buy from any where in the country)

Thank you
-Alex

AlexMacTools · 05-11-2009, 12:41 AM

p.s. im willing to trade tools, and i will buy from any where in the country, not just So Cal...
thanks.

volaredon · 02-07-2010, 10:02 AM

a ride in that tool truck to IL would be a bit far.... though I have some stories about a couple of my old Mac guys that you might be interested in (about pizz poor service)

I'm out of wrenching but I have a bunch that could use warranty-ing since we (again) lack a Mac rep around here.

340SIXPACK · 02-10-2010, 07:36 AM

I have a set of 360 heads, the engine ran good when i took it out of my challenger ,i would do a valve job on the before install i would let them go for 150.00 the only thing they need is rocker shafts and rockers let me know . Anthony

05-10-2009, 07:06 PM	#1 (permalink)
AlexMacTools Junior Member Join Date: Jun 2008 Location: L.A Posts: 6	LOOKING TO BUY 360 HEADS!!!! Looking to buy a good pair of heads for my 360, im looking for "Magnum" heads or standard 360 heads Let me know im in the Southern California area, i will pick up if necessary.(will trade tools, and will buy from any where in the country) Thank you -Alex Last edited by AlexMacTools; 05-11-2009 at 12:42 AM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
318 with 360 heads	devilkin4	General Discussion	19	05-23-2009 01:31 AM
where to buy??	sgp7679	General Discussion	5	04-19-2009 12:51 AM
Rebuild old heads, or buy new?	Commando	B-Body	32	09-24-2008 11:03 AM
Should I buy this??	mcarmaniac	B-Body	15	03-23-2008 12:59 AM
old school 360 to new style 360	choelzer	General Discussion	2	02-29-2008 04:00 AM

05-11-2009, 12:41 AM	#2 (permalink)
AlexMacTools Junior Member Join Date: Jun 2008 Location: L.A Posts: 6	p.s. im willing to trade tools, and i will buy from any where in the country, not just So Cal... thanks.

02-07-2010, 10:02 AM	#3 (permalink)
volaredon Member Join Date: Feb 2010 Posts: 67	a ride in that tool truck to IL would be a bit far.... though I have some stories about a couple of my old Mac guys that you might be interested in (about pizz poor service) I'm out of wrenching but I have a bunch that could use warranty-ing since we (again) lack a Mac rep around here.

02-10-2010, 07:36 AM	#4 (permalink)
340SIXPACK Junior Member Join Date: Jul 2008 Location: hoodriver oregon Posts: 3	I have a set of 360 heads, the engine ran good when i took it out of my challenger ,i would do a valve job on the before install i would let them go for 150.00 the only thing they need is rocker shafts and rockers let me know . Anthony