727 shift linkage adjustment!
06-10-2008 | 10:30 PM
#1
Thread Starter
Mopar Fanatic
Joined: Feb 2008
Posts: 290
Likes: 0
From: Edmonton, AB
727 shift linkage adjustment!
Hey guys.
Is there a trick in adjusting the shift linkage on a 727 with a floor shifter. Everything seams to be working fine, just that the gears don't match up with whats shows on the shifter. IE: P is P R is 1/2 way between P and R, N is R, D is just before N etc!
Is there a trick in adjusting the shift linkage on a 727 with a floor shifter. Everything seams to be working fine, just that the gears don't match up with whats shows on the shifter. IE: P is P R is 1/2 way between P and R, N is R, D is just before N etc!
06-11-2008 | 03:23 AM
#2
Guest
Posts: n/a
This is on a 64 ...correct ?
The EZiest way is to crawl under the car ...with someone in the drivers seat and just fiddle with the thumb-wheel adjustment which is bolted to the trans case.
If it is not far-off .. it should not take you longer than 10 minutes or so(with a helper).
The EZiest way is to crawl under the car ...with someone in the drivers seat and just fiddle with the thumb-wheel adjustment which is bolted to the trans case.
If it is not far-off .. it should not take you longer than 10 minutes or so(with a helper).
02-02-2010 | 07:25 PM
#3
Junior Member
Joined: Jan 2010
Posts: 10
Likes: 0
From: 1 HOUR EAST OF CLEVELAND OHIO
HI, I HAVE A 64 SPORT FURY ALSO . MY CONSOLE IS OUT AND SOME ONE PUT IN A PUSHBUTTON. I HOPE I DON'T RUN INTO THE SAME PROBLEM. THERES A PLACE I HEARD IS REAL GOOD AT KNOWING ALL THE ANSWERS . IT'S TOURKFLIGHT PATTYS PHONE # 206-356-1966 . HOPE THIS HELPS
Thread
Thread Starter
Forum
Replies
Last Post
demetri
Transmissions, Transfer Cases and Rear Ends
10
04-22-2014 03:28 PM
70Coronet
Transmissions, Transfer Cases and Rear Ends
0
04-20-2012 05:28 PM
