That's what I thought a scamp was, a prehistoric neon, junk unless you made a hotrod out of it.:uzi:

Good Afternoon.... Your rite... Thin azz tin can's....lol
Today I'm stuck with (ARB) Periodic Smoke Inspection Fleet Program Test get ready's for Tuesday.... They call it (PSIP).. Go figure.
I'm a little PISTED my self..... Ok... I crack myself up....:laugh:


Good Day Y'all....:)

Good day to ya all, I have been working on my house today, painting trim in a bedroom. Sure glad i'm not paying me by the hour because it takes me twice as long as it should......

I hope to get out in the shop yet this fall, get started on an axle swap in my Fairlane.

Iowan: Going 9" I hope????? I'll cheer you on !!!!
Good Evening Y'all.... I'm late.... But hay... I'm checking in....
Hope you all had a great day.. Taking the Scamp out for a cruise..
Y'all have fun now !!!

8.8, I'm lucky I have Quick Performance in Ames Ia., they did tubes, ends and axles for $600. I have a 1350 yoke and a carbon fiber clutch kit for it but have not decided on brakes yet, it depends on what I use in front. It will be hung with a complete Caltrak setup, this and the snotty 289 will make a fun summer daily driver.:) Should be a mid 11 second car.

Sounds like fun time's.....Iowan
Having a another bad day... Now I have a headache.:doh:

Evening now, everything is well, hanging out with the dogs and being lazy.

Lazy is good !!!!! At times... :)

Evening Y'all...... Long day.... See you in the Morning.....

Watch the good stuff folks: http://livestream.com/MotorManiaTV/2016YBNats

Lots of good racing.... Pulling for the Mopars.... Underdog's !!!!!!!!!!!

Well Good Morning all you Mopar Brothers and Sisters !!!!!!!
Going to be an awesome day here in SO-CAL !!!!
Going to be around 80*
We are going out to was vehicles today. Then I get to go look at a Honda check engine light and then over to look at a Lexus 300 for a over heating problem.. Driving the old Scamp of course...lol

Now get out there and do something to your old ride... Tell us what your up to today ????? Yes we want to know !!!

What are you working on today ?????????????

Attachment 10633

Good Evening Y'all..... Working on a 1992 Lexus SC400 4.0L V-8... What a pile of you know what.... Anyway... Thats my story for today....

Had A MR4SPEED Sighting..... Glad you stopped in.... Good to see you !!!!! Hope you are well?

Good morning all, 5:12 am here and just sitting down to my first cup of coffey.

Hope everyone has a great day!:)

Me too. My oldest son got in from Alberta safe last night, dogs went nuts happy. I've got all week off, rehersal Friday, wedding Saturday.

Hopefully the rain will hold off that's coming.

Good Morning Mopar world !!!!
Got up to a nice 56* morning, and the day will turn out to be about 85* here in SO-CAL..... Headed back out to work on the Lexus.. These things have a Hydraulic driven engine cooling fan, I dont understand engineers some times !
Well back out to work at home..... I'm like Coronet 500, I'm off for this week. :)

Coronet 500: Sounds like an awesome week planned.. Good times with family :) Hope all goes planned with the Wedding...

Iowan: I'm working on the number 2 cup at the moment.....

After I fix this Lexus.... I get to wash Mommas 55 Chevy Sedan....

Attachment 10637

Just got back from talking with my buddy about getting into my 9.5 motor. I have a set of bushed rods and I'm thinking about ordering a set of custom pistons in the 13 to 1 range so I can run e-85 with it also. I think I would go with the 590 cam I have on the shelf also, that should bump the hp from 525 to?

Now why would you put that cam in a 580CI motor?
What you bumping the H.P. from 525hp to 475hp...lol
Just funning with you... :)
.590 are all over the place on there specs. Seem to work well for going 10's in the heavier cars....
Is the E85 at your local fill'em up?

This is Iowa buddy, corn capital USA, there is guys running 1200 RWHP on the stuff locally. But its LS bowtie power. :naughty:

If I go bigger than the 590 cam I'd have to get into springs etc. and I have the cam.:)

Yummm Corn and Tamales come to mind...Not E85..lol.:)

Just got done helping my buddy with is 1200HP Bob Penella Motor, He needed more H.P. to run the NMCA and PSCA Hot Street class, Runs a 400ci SBF with the New NHRA approved Holley EFI... Kind of Cool, Make good power on the dyno and also got some good promising numbers shaking it down. 03 Stang, 8.23 out of the trailer in the 1/4... Went thew the lights @ 9700rpm..

Bowtie's... Those dont even get my attention till they start running down in the 4.05's range in the 1/8 mile. You can go to Vons and buy Head Gaskets and Pistons if you need some.

Us Mopar guy's have to go way out to try to get parts to do anything with. Most of it is old old technology unless you get into newer fuel motor stuff or Pro Stock stuff, And most of us are not in that club... :(

Rant over....lol

Whats heads are you thinking about using?

the ones i got! what else?

This is my back up motor, just thinking about adding 4 points of compression. and a little more cam. I just want to use my same carb and fuel.

Oh those....:rolleyes:

I see... What are you going to use to go forward?

Ok.. Im confused... So your taking off the corn and adding a carb !!!!

"Shhhhh Y'all..........I'm sure i'm in for it now":doh:

I give up

i know... I'm hopeless..:slap:...lol

Nice... Should run Sweet.. :)

Good Morning Y'all..... Going to be a Nice 90* here in SO-CAL today..
Working on Brand-X today...
And I thought I was going to be on Vacation... Hahahahahahaha Silly me !!

Whats in your day ahead?????

Good morning Y'all... Have a great day..... Off to the local Fair today.... Dont know what to work on later today...

(Please note Vulgar Language) Please Mute music if you think you might be offended... ;)

My life story>>>>
:)

Good morning Y'all..... Going to be a nice 80* day here in SO-CAL.....
Sooooooo, I'm going to head over to our Downtown and see some old friends and have a few laughs.... Then come home and work on a Honda car...

http://www.socalcarculture.com/Image...16Monrovia.pdf

Just thought I would share..... :) :)

Attachment 10653

Good Morning Y'all.... Going to be a good day here in SO-CAL... 87*....

Long time friend Steve Magnante helped out with a cool Dodge Commercial...:)


I thought it was cool.
Have a great day Eh !!