I have two 1969 340 motors for sale.

1. 1 season old with aluminum mopar performance heads. 12:1 compression (needs race fuel). Crane cam 590 lift 300 duration. Mopar performance rocker arms. Kieth black pistons and rods. All ARP fasteners. MSD pro billet distr. Milodon oil pan. Melling high volume oil pump. Needs intake carb and water pump to run. motor ran low 12's in a 4 spd 70 Duster. The mnotor is ready to go. $3500. I do have a Holley strip dominator intake and a edelbrock water pump if you need but they are not on the motor.

2. Needs put togeather. Block has just been 30 over. cam bearings are installed. new pistons and rings. 2 cranks forged and steel. Needs rod and main bearings to install. Have all oroginal and new parts to install. Has new Comp cam and lifters. Comes with 2 instakes aluminum and original steel. comes with alot of parts. $1800.00

Location near Fresno, California

 

would you please provide the numbers located on the block on the pass. side just above the oil pan rail. Thank you

 

Sorry it took so long to reply,One of the blocks is a 1968 and the other is a 1969. here is the numbers.#1. 2780930-340-7 11-69 built just needs intake and water pump.#2. 2780930-340-2 6-68 needs assembled.Dave

 

I am looking for the VIN number on the side of the motor(69). Passenger side just above the oil pan rail. They should be stamped.

 

could u provide some pictures of it

 

I'll try to get to the shop this week to pull them out and get the numbers and take some pics.

Dave

 

Looks like cr241 without scraping any paint off. thats on the 69 block.
Dave

 

Hi...I looking for factory 340 exhaust manifolds from 1968-70.
Do you have a set for sale?

Thanks
Wilson
email Denny45@sympatico.ca