Mopar Forums - Search Results

Go Back  Mopar Forums > Search Forums
Reload this Page >

Search Results

Search: Posts Made By: Dane Trask
Showing results 1 to 12 of 12
Search took 0.00 seconds.
05-25-2018, 07:28 AM
Replies: 1
Views: 189
Posted By Dane Trask

adjustable rocker kit

Has anyone installed an adjustable rocker kit for a Mopar SB (360 specifically)? Like this one, https://www.jegs.com/i/PRW/228/3331811/10002/-. This is my first Mopar and I am just used to adjusting...
05-22-2018, 04:52 PM
Replies: 10
Views: 408
Posted By Dane Trask

Iowan is closest!! The winner is! EITHER! ...

Iowan is closest!!
The winner is! EITHER!

These are the best runs:
750 one stage lean (rod only) orange springs: 260.3(hp)@5350(rpm), 312.4 (lb-ft)@3000(rpm), AFR=11.5, duration 8.324sec
600...
05-22-2018, 05:51 AM
Replies: 10
Views: 408
Posted By Dane Trask

DYNO DAY!!! :) I have 3 hours on the Dyno to...

DYNO DAY!!! :)
I have 3 hours on the Dyno to tune both the 750 and 600. I am pumped. Yesterday I freshened up the ignition system and took care of a miss that was happening at low rpm, (I think the...
05-15-2018, 05:16 PM
Replies: 10
Views: 408
Posted By Dane Trask

600cfm or 750cfm on a 360

I have two edelbrock carbs both in like new condition; 600cfm electric choke, 750cfm manual choke. I think my need is right in the middle. I have time on a tuning dyno next Tuesday, I have rejet kits...
05-15-2018, 04:59 PM
Replies: 4
Views: 264
Posted By Dane Trask

OK, after reading a bunch of posts on this issue,...

OK, after reading a bunch of posts on this issue, I bit the bullet and pulled the intake off, blocked the exhaust crossover, and sealed everything really well. I went back to the 600cfm carb, set the...
05-14-2018, 11:47 AM
Replies: 4
Views: 264
Posted By Dane Trask

Hard start when hot

I have a 360 with a mild cam, Edelbrock 750 on a Weiand intake. After running the intake gets so hot it is vaporizing the fuel in the runners and carb. I have a heat spacer already, but it is bad....
05-06-2018, 09:44 AM
Replies: 14
Views: 503
Posted By Dane Trask

More progress. Maybe these things will help the...

More progress. Maybe these things will help the next guy. So I was still having a rough idle and hard hot starts so I started going through the ignition system. Adjusted the air gap on the magnetic...
04-02-2018, 05:49 PM
Replies: 7
Views: 507
Posted By Dane Trask

My fan clutch was making a similar sound, and it...

My fan clutch was making a similar sound, and it is right in front of the crank. check that.
04-02-2018, 05:45 PM
Replies: 14
Views: 503
Posted By Dane Trask

That's right where I settled on. Any lower and I...

That's right where I settled on. Any lower and I have hard starts, higher I lose my lowend torque. Thank you very much.

I also figured out I had a low fuel pressure and a percolating issue. The...
03-25-2018, 08:52 AM
Replies: 14
Views: 503
Posted By Dane Trask

All good. I appreciate all of your ideas. I will...

All good. I appreciate all of your ideas. I will post if I have more issues.
03-25-2018, 07:55 AM
Replies: 14
Views: 503
Posted By Dane Trask

Ok, I said I was not a builder as evidence of...

Ok, I said I was not a builder as evidence of this post.
ALL is good. I did not know I was supposed to plug the vacuum advance on the disti when I time the motor. Once I did that it is right at...
03-24-2018, 04:50 AM
Replies: 14
Views: 503
Posted By Dane Trask

1979 lil red express 360 is having issues with timing

I bought a lil red express with a 360, that the previous owner had "modified" and I am trying to even it out a very rough idle. The last owner put in a purple shaft 284lift/484dur, a Wieand Stealth...
Showing results 1 to 12 of 12


 
Forum Jump

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.