Stock factory 2003 DODGE DAKOTA R/t
12-19-2019, 03:54 PM
#1
Stock factory 2003 DODGE DAKOTA R/t
I'm going to run a 500-600 horsepower 408 small block mopar in this extended cab Dodge Dakota r/t with a 727 auto transmission with the stock factory rearend.what suspension upgrades do I need to do to be able to handle this much horsepower and for I will be able to hook up off the line.and technical knowledge and information would be greatly appreciated Thanks In advance!!!
12-19-2019, 04:44 PM
#2
Super Moderator
what suspension upgrades do I need to do to be able to handle this much horsepower and for I will be able to hook up off the line.
All of them!
All of them!
Last edited by Iowan; 12-19-2019 at 09:50 PM.
The following users liked this post:
GDane1 (12-20-2019)
12-20-2019, 12:49 PM
#4
Super Moderator
I don't know what axle assembly you have but for that kind of power a 9" or Dana 60 is needed.
Thread
Thread Starter
Forum
Replies
Last Post
GDane1
Transmissions, Transfer Cases and Rear Ends
0
12-18-2019 10:05 PM
