Newbee
#1
Newbee
I'm new to the forum and have just acquired a project. 1967 Coronet R/T 440. During my eval of the gem I noticed the torsion bar cross member has quite a lot of rot at the ends by the rockers, the rockers look good though. I see AMD has the replacement cross member.
Has anyone had any experience with the AMD cross member? Quality? Fitment?
Can the cross member be replaced with the floor intact or will I have to remove a section to gain access?
Any advice would be greatly appreciated!
Has anyone had any experience with the AMD cross member? Quality? Fitment?
Can the cross member be replaced with the floor intact or will I have to remove a section to gain access?
Any advice would be greatly appreciated!
Thread
Thread Starter
Forum
Replies
Last Post