8.75 Third Member - 489 case
1 Attachment(s)
Here is my Chrysler '489 case third member that was magnafluxed, prepped, and built out by Mark Williams. It was built as a part of the low drag process with their billet caps, 35-spline aluminum spool, all new bearings, seals and Mopar pinion coupler, etc. Details of set up are in the work order that is included. I was orginally going to use this thirdmember for a front engine dragster project to run Nostalgia Eliminator and Pro 7.0 classes. I ended up selling the dragster chassis to a guy who did not want the rearend components (I also have an unmolested housing - see my other listing). This third member has not been run and has been wrapped and kept in my shop that is climate controlled. I held onto this just in case I built another chassis. Here are some of the specifics:
Richmond Gear Set - 629-0058 (3.91:1) MW Spool - 53179 (35 spline) MW Coupler - 40500 (10 spline) If you're looking for a near bullet-proof 8.75 thirdmember, look no further. Asking $1500, OBO. Located in Chino Hills, CA; email: vincent@mayedamotorsports.com http://i268.photobucket.com/albums/j...ucts/489_2.jpg http://i268.photobucket.com/albums/j...ucts/489_3.jpg Attachment 16909 http://i268.photobucket.com/albums/j..._workorder.jpg |
Sold. Thanks.
|
All times are GMT -7. The time now is 09:50 PM. |
© 2024 MH Sub I, LLC dba Internet Brands