Replacing metal decrease value?

Old Jun 25, 2017 | 07:22 PM
  #1  
Tom T2's Avatar
Thread Starter
New Member
 
Joined: Aug 2015
Posts: 17
Likes: 0
Replacing metal decrease value?

Does replacing any amount of metal decrease the value of any classic car? How significant will it decrease? Would if it was one panel vs would if it was a big potion of the car including mutiple panels and peices? Question came up and was wondering what you guys think.

Thanks, Tom
Reply
Old Jun 26, 2017 | 09:53 AM
  #2  
RacerHog's Avatar
Mopar Lover
 
Joined: Jun 2013
Posts: 11,096
Likes: 955
From: Monrovia SO-CAL (USA)
Like everything else... The purer it is.. The more it is worth in most cases.
If the repair is done were you cant tell. That's a +... If its repaired and you can see it. Well It will not be considered untouched.
Reply
Old Jun 26, 2017 | 05:15 PM
  #3  
Iowan's Avatar
Super Moderator
 
Joined: Mar 2015
Posts: 5,482
Likes: 553
Compared to rust, bondo and dents?
Reply
Old Jun 27, 2017 | 08:12 AM
  #4  
Tom T2's Avatar
Thread Starter
New Member
 
Joined: Aug 2015
Posts: 17
Likes: 0
Originally Posted by RacerHog
Like everything else... The purer it is.. The more it is worth in most cases.
If the repair is done were you cant tell. That's a +... If its repaired and you can see it. Well It will not be considered untouched.
The way I see is it's better to replace a lot of metal than letting the car rot away. My situation is I have a 1968 Charger R/T with a 440 all optioned out. Numbers matching engine and tranny, powered window, disc brakes, A.C., etc etc. But I have replaced a lot of panels but I did a nice clean job. Pretty much the floor back from the fire wall to the rear of the car is all replaced, rear frame rails, tail panel, rear valence, rear deck filler, rims of the truck opening, half of both quarter panels, upper cowl panel, probably going to get a new trunk lid, patch a part of the engine bay and need new fenders.
Reply
Old Jun 27, 2017 | 01:55 PM
  #5  
RacerHog's Avatar
Mopar Lover
 
Joined: Jun 2013
Posts: 11,096
Likes: 955
From: Monrovia SO-CAL (USA)
Well, in that case if your did an awesome job. I would say you have not decreased the Value !
Lots of good parts out on the market for those who have the talent to do great replacements for sheet metal. Here in SO-CAL you see allot of DYI folks that get in way over their head very fast, and then cant find the point of no return. Well I guess that's just not here in So-CAL... I'll take that back.
But you get the point.
Now Iowa, just uses Rust, Bondo, and some Potato's for filler and a rattle can to paint it, and your done.. ( Note: Just a dagger for my buddy Iowan )
Reply
Old Jun 27, 2017 | 02:05 PM
  #6  
Iowan's Avatar
Super Moderator
 
Joined: Mar 2015
Posts: 5,482
Likes: 553
Now Now Bob, the last car I built I had close to 2000 hours in paint and body work! That's one hell of a lot of work and $ to put into a 55 chevy but I got paid!.

Last edited by Iowan; Jun 27, 2017 at 05:12 PM.
Reply
Old Jun 27, 2017 | 04:09 PM
  #7  
Magoo's Avatar
Mopar Fanatic
 
Joined: Jun 2015
Posts: 204
Likes: 6
From: N.E. Pa.
Thumbs down Replaced Panels

I'm not a fan of -- Rust - Bondo - and replaced panels. -- Clean, and original, for Me. --
Reply
Old Jun 27, 2017 | 04:11 PM
  #8  
Magoo's Avatar
Mopar Fanatic
 
Joined: Jun 2015
Posts: 204
Likes: 6
From: N.E. Pa.
Originally Posted by Iowan
-- That's one hell of a lot of work and $ to put into a 55 chevy --
-- a Chevy ?? -- --
Reply
Old Jun 27, 2017 | 05:10 PM
  #9  
Iowan's Avatar
Super Moderator
 
Joined: Mar 2015
Posts: 5,482
Likes: 553
Not mine, I only work for the money.
Reply
Old Jun 27, 2017 | 05:30 PM
  #10  
Iowan's Avatar
Super Moderator
 
Joined: Mar 2015
Posts: 5,482
Likes: 553
Tom
Sounds like you saved the car and there was no where to go but up, there is a value difference between all original panel's and a reconstructed body no doubt. What it is?
Reply
Old Jun 27, 2017 | 08:39 PM
  #11  
Tom T2's Avatar
Thread Starter
New Member
 
Joined: Aug 2015
Posts: 17
Likes: 0
I appreciate the response, my friends. You all had some very good talking points and it helped a lot! I'm sure I'll be back soon asking questions as I go. I'll share some pictures of it in the future when it's starts looking like a car again. I'm just happy I saved such a desirable car, especially when it's an optioned out charger R/T, plus has powered windows which is quite rare from what I have heard.

Thanks, Tom
Reply
Old Jun 28, 2017 | 01:22 PM
  #12  
RacerHog's Avatar
Mopar Lover
 
Joined: Jun 2013
Posts: 11,096
Likes: 955
From: Monrovia SO-CAL (USA)
Keep us posted for sure....
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Emily Grace
Engines, Exhaust and Fuel systems
9
Jan 26, 2016 06:52 PM
72D100dodge
Classic Trucks (pre-1972)
5
Apr 15, 2012 07:15 PM
AV8AP6
Do-It-yourself Section
1
Apr 1, 2012 04:19 PM
Dartingtraffic
Do-It-yourself Section
9
Oct 18, 2011 04:55 PM
stazja01
General Technical Questions
3
Nov 17, 2008 04:24 AM


Thread Tools
Search this Thread

All times are GMT -7. The time now is 05:24 AM.