Hello. My family has a 1965 Plymouth Sport Fury. Its been in the family for around 15 yrs. We have had it for around 10. We just recently upgraded the cast intake to an edelbrock performer and 4 bbl 600cfm elec. choke performer carb. We had the tranny rebuilt and a shift kit installed. I know its not all original. The motor is out of a 71'. I found that out with the casting #'s. I dont know if the tranny is original. It has the 727 casting. I know there were 3 rear axles avail. I want to say it is the 489 i think. Dont know off the top of my head. But i do thinkits the smallest pinion shaft out of them all. Other than routine mait. on it like replacing all brakes, wheel bearings. Its pretty much stock. There is alot more work in store. And dont really have a time frame or a finish date. We work on it for a couple months than dont mess with it for a couple months. Doesnt hurt to see it sit there. I will take some pics later and post them up.

Thanks,

Chris

 

Welcome!

 

Welcome to the show.

 

Welcome to the forum!

 

welcome to the forum

 

Hey Chris... Welcome to the forum... What part of La????? I go there about every six to eight weeks.....

 

Welcome!

 

Welcome to the forum, there are a lot of good people here to give you helpful advice to get you through your project

 

welcome aboard, is your fury a 2 or 4 door. Let us know if we can help you with anything.

 

Way, Waaaaaay north. About 30-45 minutes from arkansas. Little town called Ruston. Its where Louisiana Tech is. About 30 minutes east of Grambling.

 

Its a 2 door fury. I posted a new thread on some possibly mechanical or electrical issues I am having. Take a look.

Thanks for the warm welcome. I dont know much but I know a little.

Thanks agian.

Chris