Air grabber hood moulding
01-29-2020, 11:46 AM
#1
New Member
Thread Starter
Join Date: Feb 2019
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Air grabber hood moulding
Hi everyone, I need to pick some minds on a possible option for the rubber molding on my air grabber hood.
I had some motor work done on my 69 440 GTX that included a new Eldebrock aluminum dual plane intake manifold topped with an Eldebrock 750 carb. The problem is when I went to close the hood the intake is just slightly higher than the stock manifold so the hood would not close correctly. I had to take the rubber moulding on the air grabber off so now the hood closes fine. Is there an alternative thinner moulding that can be purchased that I can install? Thanks!
I had some motor work done on my 69 440 GTX that included a new Eldebrock aluminum dual plane intake manifold topped with an Eldebrock 750 carb. The problem is when I went to close the hood the intake is just slightly higher than the stock manifold so the hood would not close correctly. I had to take the rubber moulding on the air grabber off so now the hood closes fine. Is there an alternative thinner moulding that can be purchased that I can install? Thanks!
Thread
Thread Starter
Forum
Replies
Last Post
