is this clutch or cone type? look at pic
#2
Look down inside the holes, can you see springs that resemble valve springs? That appears to me to be what you are calling the "cone" type
http://images.moparmusclemagazine.co...8_gear_6_z.jpg
http://www.moparmusclemagazine.com/h..._up/index.html
Here's a very good page:
http://www.usaimports.co.uk/Mopar_Te..._rear_ends.htm
and here, from the above link, is a pic of a "sure grip"
http://www.usaimports.co.uk/images/m...%20end%204.jpg
Notice how the end of the housing is bolted on, and is "straight sided", and finished machined, not cast and tapered.
http://images.moparmusclemagazine.co...8_gear_6_z.jpg
http://www.moparmusclemagazine.com/h..._up/index.html
Here's a very good page:
http://www.usaimports.co.uk/Mopar_Te..._rear_ends.htm
and here, from the above link, is a pic of a "sure grip"
http://www.usaimports.co.uk/images/m...%20end%204.jpg
Notice how the end of the housing is bolted on, and is "straight sided", and finished machined, not cast and tapered.
Thread
Thread Starter
Forum
Replies
Last Post
deadkelly
MoparForums Help and Suggestion Center
4
10-10-2008 04:12 PM