MSD6c swap to rev-n-nator,no spark
Thread Starter
New Member
Joined: May 2018
Posts: 3
Likes: 0
MSD6c swap to rev-n-nator,no spark
so decided to change from MSD6c to a rev-n-nator. 3 years ago a rev-nator was tested on engine dyno along with my 6c. It produced 9 horse power more. Now decided to go with this rev-n-nator mostly for the rev control feature.
Unhooked MSD,hooked up ballast and new ICU.no fire! Hooked up a plain mopar box,no spark.
What am I missing?
Mopar connection at MSD is 5 pole.
noticed rev-n-nator is 4 pole left bottom missing
mopar box has 5
I thought it would start with original mopar electronic box
Any help,much appreciated!
Unhooked MSD,hooked up ballast and new ICU.no fire! Hooked up a plain mopar box,no spark.
What am I missing?
Mopar connection at MSD is 5 pole.
noticed rev-n-nator is 4 pole left bottom missing
mopar box has 5
I thought it would start with original mopar electronic box
Any help,much appreciated!
Mopar Lover
Joined: Jun 2013
Posts: 11,074
Likes: 953
From: Monrovia SO-CAL (USA)
Have you checked with FBO and 4 seconds? What did they say?
I would double check the wiring... Might not have the crank wire live??????
I'm Not sure what the 6C is ????? Help me out here....
I would double check the wiring... Might not have the crank wire live??????
I'm Not sure what the 6C is ????? Help me out here....
Last edited by RacerHog; Jun 2, 2018 at 08:05 PM.
Thread
Thread Starter
Forum
Replies
Last Post
sendust
General Technical Questions
11
Aug 27, 2019 05:16 PM
Mason440cuda
Engines, Exhaust and Fuel systems
9
Jun 13, 2018 01:56 PM
