I purchased upper control arms/ball joints and spindles for a disc brake conversion to my 66 Coronet 500 convertible. Is there a washer that goes between the spindle and the upper ball joint? The ***** joints included a typical and a thick washer, but I'm not sure where they go. The only washer I am aware of is between the castle nut and the spindle.


And finally...anyone in the Detroit area know a good alignment guy?


Any thoughts are appreciated.


Thanks!

 

One between castle nut and spindle
One between Outer wheel bearing and castle nut...
But with the conversion... You might have 2 washers left over...

 

Much appreciated!