I am new to this site and hope that someone can help me out with a problem I am having. 65 Barracuda that a previous owner has installed a front disk brake conversion kit on. Manual brakes. My problem is that I can't get the camber set and keep it set. I set it, roll around the block and it goes right back out of alignment. 4 New bushings. Same problem! Any ideas? Thanks for any and all suggestions.

 

Did you change the ball joints ?

 

All new ball joints, new bushings and tie rods. The only parts that are not new are the cam bolts, but they appear to fit right and I torque them down pretty good! Thanks for the reply!

 

It's bending the adjuster tab's is it.... that was a problem with some of those..

 

So how does one fix that? Weld new ones on that are made of stouter material? TY

 

Yes... You nailed it.....
Keep us posted....