mrzods13

Looking for mopar cylinder heads to buy. Looking for a set that is redone and assembled and looking to spend around $450 - $500 shipped. Want something with hardened seats 346 452 or 906 if the seats were added.

RacerHog

Try these Guys....

http://cylinderheadexchange.com/home

TVLynn

I would bet they have a core charge !! It's not going to be cheap.. May even be cheaper to find a motor home engine cheap

RacerHog

Hahahahahaha...Lynn..... Mopars are never Cheap.....

mrzods13

Would Fel Pro 8519PT1 Gaskets be ok for the heads, buying new bolts, but can't find dowels, don't know if I need them still havent taken the old heads off.

RacerHog

That number looks like a head set.... But you would have to look it up. I'm not sure of the part number....

However My suggestion will be to look at the cooling holes in the gasket and the heads you get and make sure they match....

Mr.4spd

Right? Why is that? What the crap!

mrzods13

Well I took the heads off today, looks like they put flat top pistons in the block .30. Will the 346 heads still be ok with those.

moparted

IF you ARE HAPPY WITH A 8 to 1 cr

TVLynn

You would need to check the deck height of the pistons and figure the compression.....
Going back a few years mid 70's I built a 383 ? may have been a 361 LONG time ago...
12 1/2 TRW forged pistons could not get it to stop pinging had to swap to 906 heads to lower the compression-- it worked !!!