360 performance
#1
360 performance
i have a 360 bored .30 over with a mild cam i was wondering what would be a good set of heads and an intake i have the stock intake and i have 2.02 heads now should i stick with those heads or is there something better out there im also running a elderbrock 650 also have 4.10 gears im building the truck for tug a truck or truck pulling
Last edited by ClemM882; 12-04-2012 at 03:14 PM.
#3
Just for reference I gained 41 RWHP by removing ported 340 X heads & installing ported 308s with stock valve sizes . So they are better heads for a production head , The RHS heads are a good choice aftermarket , but most 360s had very low compression so that should be addressed as well if it is stock , an RV cam will help build cylinder pressure .
Thread
Thread Starter
Forum
Replies
Last Post
68Dart
Transmissions, Transfer Cases and Rear Ends
5
03-17-2019 05:43 PM
dpmalibu
Part(s) for Sale
18
08-03-2013 06:05 PM
NYH1
General Technical Questions
5
07-02-2009 11:03 AM
TwistedWrenches
Do-It-yourself Section
39
03-12-2009 07:28 PM